Path to get to Output Channel Diagnostics screen on a injection molding machine: F10 next –> F4 IO –> F2 PB –> F6 set PB If the PCB board is malfunctioning, you can transfer the malfunction point to the unused input point.Please consult the producer for the password.
Read more →Path to get to Input Channel Diagnostics (PB) screen: F10 next –> F4 IO –> F2 PB –> F2 PB1 PB2、PB3、PB4 and PB1picture and function are similar. PB2、PB3、PB4 and PB1picture and function are similar. You can use this display screen to ensure the connection between the controller and […]
Read more →Path: F10 next –> F3 adjustment –> F3 DA1 DA2，DA3，DA4 and DA1 picture and function are similar Output force: DA correction during the test output, the corresponding channel’s output continued to the timing, when the timing has reach the limit , the output will automatically be cut […]
Read more →Path: F10 next –> F3 adjustment –> F2AD The replacement of foot position or modify some of the mechanical parts, so re-location of the zero correction is needed (in manual mode only): 1. Please insert the password 2. Please switch the part to zero according to the requirement […]
Read more →Path: F10 next –> F2 monitor –> F7 parameters F7 parameters The value could be set according to the actual production demand.
Read more →Path: F10 next –> F2 monitor –> F6 counting Total amount of mold open zero-mode: If you want to enter a zero mode after the opening mold, please select“use”, then press key to clear and recount the total. Total amount of target production: Setup the production amount you required , […]
Read more →Path: F10 next –> F2 monitor –> F4 test 2/F5 test 3 F4 test 2 F5 test 3 This monitoring screen allows you to compare the most important production cycle parameters. Use this screen to compare production parameter deviation during machine operation. The parameter comparison of different […]
Read more →Path: F10 next –> F2 monitor –> F3 test 1 The HMI and controller provide you with an automatic monitoring and alarm system. The system allows you to set a desired operating range with upper and lower limits (Delta Values) for each production parameter. Once the current parameter value exceeded […]
Read more →Path to get to alarm display screen: F10 next –> F2 monitor –> F2 alarm Display Start No: The screen displays 8 error messages at a time. If you want to refer to the previous recorded errors you can enter here the error number for the first error to […]
Read more →In this article, we will show you the path to get to fast set mold adjustment parameters settings screen. So you can adjust all cor-responsible parameters of the mold adjustment according to your actual production. Path: screen –> F9 fast set –> F4parameters This screen consists of all cor-responsible parameters […]
Read more →
